Search for: All records

We investigated the enhanced vapor responses and altered response ratios of a series of thiophene (co)polymers with oxygenated side chains (CH 2 OH, linear polyethylene glycol, and crown ether), including the novel poly(3-hydroxymethylthiophene) (PTOH) and other newly synthesized polymers. Hydroxymethyl-containing copolymers had higher mobility compared to poly(3-hexylthiophene) (P3HT). The larger crown ether moiety promotes transistor characteristics of P3HT while the smaller one impairs them. Incorporating different oxygen bearing functionalities increased responses of thiophene polymers to NO 2 , NH 3 , and acetone. For example a polyether side chain increases the NO 2 response sensitivity of copolymers of both P3HT and PTOH, but sensitivity towards gas analytes was more prominent for glycol-based functionalities rather than the crown ethers. PTOH is very sensitive to NO 2 and the response likely includes a contribution from conductive protons on the OH group. The lack of correlation among the rank-ordered gas sensitivities imparted by each functional group was found to be useful for designing a selective sensor array. We specifically showed high classification accuracy for all the polymer responses to NO 2 and acetone vapors, both of which gave increased device currents but with response ratios different enough to allow highly classifying discriminant functions to be derived. 

Polythiophenes with differently functionalized side chains (alkyl, oligoethylene oxide, ester, hydroxy, and carboxylic acid) and varied counterions of potassium salt electrolytes were investigated in organic electrochemical transistors (OECTs). In addition, mixed blends were investigated to evaluate any synergistic effects between functionalities. Depending on the functional moiety attached, a large shift to lower potentials of Vth, an increase in drain current, and increase in transconductance can be observed compared to the base combination of alkyl side chain and Cl-. The newly designed and synthesized hydroxy polymer displayed stability to large shifts in VTH, slight increase in drain current, and little or no increase in transconductance when an ionic radius of the dopant is increased until a much larger anion, large polarizability, and low hydration number such as TSFI- was used. The acid-functionalized polymer, on the other hand had the same magnitude in shift with respect to any anion that is larger than Cl-. The polymers were characterized by spectroscopy, x-ray diffraction, thermal analysis, and cyclic voltammetry. This work demonstrates that side-chain engineering can have substantial difference in the level of interaction in the electrolyte which would require tailoring the ion for specific polymer interactions. 

This paper reports a new mechanism for particulate matter detection and identification. Three types of carbon particles are synthesized with different functional groups to mimic the real particulates in atmospheric aerosol. After exposing polymer‐based organic devices in organic field effect transistor (OFET) architectures to the particle mist, the sensitivity and selectivity of the detection of different types of particles are shown by the current changes extracted from the transfer curves. The results indicate that the sensitivity of the devices is related to the structure and functional groups of the organic semiconducting layers, as well as the morphology. The predominant response is simulated by a model that yielded values of charge carrier density increase and charge carriers delivered per unit mass of particles. The research points out that polymer semiconductor devices have the ability to selectively detect particles with multiple functional groups, which reveals a future direction for selective detection of particulate matter.

 

The sensing properties of poly 3‐(3‐carboxypropyl) thiophene‐2,5‐diyl (PT‐COOH) and hydroxylated polythiophene (PT‐OH) as bioreceptor layers were studied and are discussed in this paper. The polymer films cover the channel region of the OECT devices and anti‐human IgG was immobilized on the polymer films. We use threshold voltage (Vth) change as a sensing signal to detect the interaction between anti‐human IgG and human IgG. By adding different concentrations of human IgG, Vth difference can be observed on anti‐human IgG immobilized polymer films, with optimized detection from a blend of the two polymers. Open circuit potential (OCP) measurement was also done on the OECT devices based on the same anti‐human IgG and human IgG interaction pair to help us understand the mechanism behind the antibody functionalization and the interaction between antibody and antigen. Importantly, the observed positive OCP change for the PT‐OH system was self‐consistent with the negative OECT Vth change that was obtained, since the latter is applied to the gate while the former is measured at the channel.

 

Efficient doping of polymer semiconductors is required for high conductivity and efficient thermoelectric performance. Lewis acids, e.g., B(C₆F₅)₃, have been widely employed as dopants, but the mechanism is not fully understood. 1:1 “Wheland type” or zwitterionic complexes of B(C₆F₅)₃are created with small conjugated molecules 3,6‐bis(5‐(7‐(5‐methylthiophen‐2‐yl)‐2,3‐dihydrothieno[3,4‐b][1,4]dioxin‐5‐yl)thiophen‐2‐yl)‐2,5‐dioctyl‐2,5‐dihydropyrrolo[3,4‐c]pyrrole‐1,4‐dione [oligo_DPP(EDOT)₂] and 3,6‐bis(5''‐methyl‐[2,2':5',2''‐terthiophen]‐5‐yl)‐2,5‐dioctyl‐2,5‐dihydropyrrolo[3,4‐c]pyrrole‐1,4‐dione [oligo_DPP(Th)₂]. Using a wide variety of experimental and computational approaches, the doping ability of these Wheland Complexes with B(C₆F₅)₃are characterized for five novel diketopyrrolopyrrole‐ethylenedioxythiophene (DPP‐EDOT)‐based conjugated polymers. The electrical properties are a strong function of the specific conjugated molecule constituting the adduct, rather than acidic protons generated via hydrolysis of B(C₆F₅)₃, serving as the oxidant. It is highly probable that certain repeat units/segments form adduct structures inp‐type conjugated polymers which act as intermediates for conjugated polymer doping. Electronic and optical properties are consistent with the increase in hole‐donating ability of polymers with their cumulative donor strengths. The doped film of polymer (DPP(EDOT)₂‐(EDOT)₂) exhibits exceptionally good thermal and air‐storage stability. The highest conductivities, ≈300 and ≈200 S cm⁻¹, are achieved for DPP(EDOT)₂‐(EDOT)₂doped with B(C₆F₅)₃and its Wheland complexes.

 

N‐Type thermoelectrics typically consist of small molecule dopant+polymer host. Only a few polymer dopant+polymer host systems have been reported, and these have lower thermoelectric parameters. N‐type polymers with high crystallinity and order are generally used for high‐conductivity () organic conductors. Few n‐type polymers with only short‐range lamellar stacking for high‐conductivity materials have been reported. Here, we describe an n‐type short‐range lamellar‐stacked all‐polymer thermoelectric system with highestof 78 S⁻¹, power factor (PF) of 163 μW m⁻¹ K⁻², and maximum Figure of merit (ZT) of 0.53 at room temperature with a dopant/host ratio of 75 wt%. The minor effect of polymer dopant on the molecular arrangement of conjugated polymer PDPIN at high ratios, high doping capability, high Seebeck coefficient (S) absolute values relative to, and atypical decreased thermal conductivity () with increased doping ratio contribute to the promising performance.

 

N‐Type thermoelectrics typically consist of small molecule dopant+polymer host. Only a few polymer dopant+polymer host systems have been reported, and these have lower thermoelectric parameters. N‐type polymers with high crystallinity and order are generally used for high‐conductivity () organic conductors. Few n‐type polymers with only short‐range lamellar stacking for high‐conductivity materials have been reported. Here, we describe an n‐type short‐range lamellar‐stacked all‐polymer thermoelectric system with highestof 78 S⁻¹, power factor (PF) of 163 μW m⁻¹ K⁻², and maximum Figure of merit (ZT) of 0.53 at room temperature with a dopant/host ratio of 75 wt%. The minor effect of polymer dopant on the molecular arrangement of conjugated polymer PDPIN at high ratios, high doping capability, high Seebeck coefficient (S) absolute values relative to, and atypical decreased thermal conductivity () with increased doping ratio contribute to the promising performance.

 

A systematic analysis is used to understand electrical drift occurring in field‐effect transistor (FET) dissolved‐analyte sensors by investigating its dependence on electrode surface‐solution combinations in a remote‐gate (RG) FET configuration. Water at pH 7 and neat acetonitrile, having different dipoles and polarizabilities, are applied to the RG surface of indium tin oxide, SiO₂, hexamethyldisilazane‐modified SiO₂, polystyrene, poly(styrene‐co‐acrylic acid), poly(3‐hexylthiophene‐2,5‐diyl) (P3HT), and poly [3‐(3‐carboxypropyl)thiophene‐2,5‐diyl] (PT‐COOH). It is discovered that in some cases a slow reorientation of dipoles at the interface induced by gate electric fields causes severe drift and hysteresis because of induced interface potential changes. Conductive and charged P3HT and PT‐COOH increase electrochemical stability by promoting fast surface equilibrations. It is also demonstrated that pH sensitivity of P3HT (17 mV per pH) is an indication of proton doping. PT‐COOH shows further enhanced pH sensitivity (30 mV per pH). This combination of electrochemical stability and pH response in PT‐COOH are proposed as advantageous for polymer‐based biosensors.